Installing the Image 

To install the software image:
• Build a Clonezilla Live USB image
• Boot the Sensor from the Clonezilla Live USB drive • Load the image
• Install (restore) the image 

Building the Clonezilla Live USB Image 

You must boot the server from Clonezilla. To build the Clonezilla Live USB image: 

1. Download Clonezilla Live version 2.6.7-28 (with the amd64 CPU architecture) from :
   https://clonezilla.org/downloads/download.php?branch=stable
2. Use the Clonezilla Live image to make a bootable USB drive.

Booting from Clonezilla 

To boot from Clonezilla, plug in the USB drive into the Data Sensor: 

1. Turn on the Data Sensor.
2. Select Clonezilla Live (Default settings, VGA 800x600).
3. Press Enter. You might see minor error messages, which you can safely ignore. The Clonezilla
   Language screen appears.
4. Select your language and press Enter. The Keyboard Configuration screen appears.
5. Select your keyboard layout and press Enter.
6. Select Start_Clonezilla Start Clonezilla when the Start Clonezilla screen appears.

Load the Image 

To load the image: 

1. Select device-image - work with disks or partitions using images.
2. Choose ssh_server (if you are pulling image from ssh server) or local_dev (if you are pulling
   image from a local device)

  a. ssh_server 

1. 1. Enter the remote server address.
   2. Enter the remote server port.
   3. Enter the remote server username.
   4. Enter the absolute path.
   5. Enter the password. The server is mounted. 

b. Local_dev 

1. Press Enter.
2. Press Ctrl-C.
3. Select the local device.
4. Select OK.
5. Verify that the image is found.
6. Select Done.

Install the Image 

To install the image: 

1. Select the Beginner mode and press Enter.
2. Select restoredisk and press Enter.
3. Select the image and press Enter. There is only one image on the USB drive.
4. When asked to choose the target disk(s) to be overwritten, select all disks except the Clonezilla
   Live USB drive.
5. Press Enter.
6. When asked if you want to check whether the image is restorable or not, select -scr No, skip
   checking the image before restoring and press Enter.
7. Select Reboot and press Enter.
8. Press Enter again.
9. Enter Y to continue and press Enter.
10. Enter Y to continue and press Enter. Your Stellar Cyber software begins the installation. This
    can take up to an hour.

The Stellar Cyber installation is complete.